-
by Ganymed Stanek
The UART that is routed to the Raspberry Pi GPIO connector header pin 8 (GPIO 14 - UART TX) and pin 10 (GPIO 15 - UART RX) is by default used for t...
-
by Ganymed Stanek
Hardware needed
- Raspberry Pi Model A or B, gen 2, 3 or 4- SD Card with capacity of 4GB or higher- Raspberry Pi compatible camera with flatban...
-
by Ganymed Stanek
Hardware needed
- Raspberry Pi to iPod HiFi 30-pin-dock Adapter for Airplay Audio Streaming from Poolside Factory. Comes with standoffs and sc...
-
by Ganymed Stanek
This is the quickest and easiest way to set up a new Raspberry Pi image that you can log into over Wifi. This works completely without the n...
-
by Ganymed Stanek
From the command line, you can easily see which Raspberry Pi hardware version you are logged into by running the following command:
cat /sys/firmwa...
Use left/right arrows to navigate the slideshow or swipe left/right if using a mobile device